----------

----------

How to Change RAM of your Laptop


ram-for-phone-photo

Step by step guide to change ram of your laptop. Laptop is our basic need in day to day usage. But most of time we start to see that it starts performing slower then usual. That can be due to virus or due to low ram. As the technology is increasing day by day. The developing softwares and applications need more system specifications then the previous ones. Hence we sometimes need to enhance our system to meet those system requirements.


One of these requirement can be seen as RAM upgradation. It is used to provide useful files to the processor from hard disk which I not directly accessed by processor. So the bigger is the size of RAM he larger data it can store hence the faster it can provide data to processor.

How to change RAM of your Laptop.
Before upgrading your laptop with additional RAM it is very important for you to find out certain info about your laptop like:

#1 Upgrade limit i.e. the amount of RAM current laptop can handle. This information can be acquired from the vendor’s website or by referring the manuals given along with the laptop.

#2 Next thing is to determine the type of RAM. There are various types of RAM like DDR, DDR2 and DDR3. Laptops purchased around 2 years back will most probably have a DDR or DDR2 RAM. Recently purchased laptops might be having a DDR3 RAM. These RAM types differ in their performance capabilities.


#3 Your laptop hardware usually incorporates slot for incorporating a particular type of RAM. This means that if the hardware has a slot for accommodating DDR2 RAM, you can install only a DDR2 RAM and not DDR or DDR3.After you have determined this you must purchase the RAM with sufficient capacity for performing the tasks.


Step-by-Step Installation Guideline

#1 You must disconnect the laptop from power sources and turn it off before dismantling it for the installation of the new RAM.

#2 Once you have done that, you will have to find out the memory compartment door. Location of this door varies in different laptops. You can find where the door is located by checking the hardware map in the manual of the laptop. The memory compartment door is usually placed in the bottom of the laptop and you will find screws attached to this door. Use an appropriate screw driver to open the door.


#3 Typically, there will be two slots for RAM. Check if both slots are occupied. If both slots are occupied you will have to remove one module(Smaller size RAM) from the slot and then install the new module(bigger size RAM). If not you can simply add the new module on to the vacant slot.

#4 Once you have placed the module on to the slot give a small push. This will enable the clips to lock the RAM on to the slot.

#5 Close the door and tighten the screws. Now you can turn on the laptop and view the BIOS screen – to check if the installed RAM has been accepted and read by the hardware unit.

If Then there you need any help Must Comment Below Or Message Us Freely.






Author:

Mukesh Bhardwaj Is a CEO And Founder of TekGyd . He is young Tech Geek who is managing iTech Hacks Network Also an aspiring blogger and Chief Editor for TekGyd.He is an Experienced Blogger,SEO Expert, Digital Marketer,White Hacker Social Media Expert.

Facebook Comment